Sundance® Spas Chelsee Temperature Sensor With Oring

(Use with 6540-228 Oring (sold separately, see below in related products.)

The Temp Sensors are located in the filter compartment on the side. They are unscrewed from the inside of the tub and the wire is fed through the tub into the equipment compartment. Follow the wire to the PC Board. To feed the new sensor, we usually drain the tub below the hole and pull the old sensor out a couple of feet into the tub, cutting the old sensor head off, we tie on the new sensor (connector end) to the old wire and pull the wire through into the equipment compartment.
The connectors on the Temp Sensor are attached to a pc board connector that is located on the PC Board (usually at the top). There are other wires connected to this plug: Jumper interlock wire,Flow Switch, High Limit and Temp sensor. Remove the pin connector from the board .
Please note: The color code on the wires have no significance, you can hook the wires up either way.
These sensors are interchangeable with the 6600-166 except for the end connector which does not connect into the 6600-167 harness. (would have to strip wires back and wire nut together.)

*FREE Standard Ground Shipping on this item, with a $4.95 handling fee on all orders (Contiguous U.S. Only)See our Shipping Policy. 

See our Facebook page for video hints for installing the temp sensor (video may not represent your  model or series):  Follow Spaandpoolsource.com on Facebook 
 

For All Sundance® Spas Temperature Sensors Click Here!.