Sundance Spas 6500-264, 6500-764 Spa Pump - 2 Speed, 2 HP, 4 Brake HP

Spa Pump for Sundance Spas

6500-264, 6500-764, 6500-137, 6500-347

Specifications:

• 12.7/3.4 Amp (measured at 4.5 HP). 10.0/3.0 Amps (measured at 4.2/2.5 HP with Sundance/Jacuzzi Wet end)
• 2 Speed
• 4.0 Brake HP, 2.0 HP continuous duty wet end
• 240 Volt
• 48 Frame
• SPH30FL2S

New Motor with Sundance/Jacuzzi Piranha Wet End

Comes Complete with the motor and wet end/pump housing. Does not come with the power cord or Hose Barb 6540-171*

The Pump is complete with an Emerson (US) Motor. The difference between the Factory Pump and ours is that ours comes with the original welded bracket on the motor instead of the bracket mount currently used by Sundance. Our pump replaces the original found in your spa that had the mounting bracket welded to it.

This can be used for other pumps by Sundance by simply adjusting the position of the wet end by loosening the 4 bolts (this is a through-bolt motor)and turning the wet end to the position of the original pump and then retightening the 4 bolts. We send the pump in the 6500-264 position which is in the 1:30 position.

Notes:

• Also replaces the 3.6 HP 2 speed pump
• We use only a Viton Seal on our Wet ends for long life. The viton seal is designed for harsh chemical environments such as salt, ozone and chemically treat water.These seals are more costly than a standard seal used by most of our competitors.
• Has the welded foot pedestal on the motor itself.
• Does not come with power cord.

Used On the Following Sundance Spa Models:

• Calypso,1998-1999
• Caypso II, 1997
• Corum, 1997-1998
• Marin, 1997, 2000-2003
• Montego, 1997-1999
• Rio, 1997-1999
• Old part number: 06120195-1

Also Used On:

• Gatsby Spas, as S35A9-B

Important:

• The parts from this pump are not compatable to the Theramax/ Theraflo/Aquaflo Pump used in 1997-1998. If yours was the Aquaflo pump used in this time period and you are wanting parts for replacement, you must use the parts listed here.
• If you are wanting the parts for the above pump used from 1999-04/2009 with the wet end pictured, please go here.

Wiring Diagrams:

Wiring PDF Download

Please Note: We send the wiring diagram for your motor which is also on the ID plate of the Motor. The Motors are 240 Volts with 4 wires: Red (High Speed), Black (Low Speed), White (240 Volt Common) and Green (Ground). Please note the manufacturer of your motor and select the correct wiring diagram. It may vary from the original wiring on your original spa motor.

For Single Speed Motor: If you ordered this 2 Speed Pump but needed a Single Speed, then you would hook up the Black (High Speed) and the White (240 Volt Common). This will work as a Single Speed.