Sundance Spas 6500-266, 6500-766 Spa Pump for - 1 Speed 2 HP, 4 Brake HP

Spa Pump for SundanceSpas

6500-266, 6500-766, 6500-349 Secondary Jet Pump

Specifications:

• 1 Speed
• 2.0 HP / 4 Brake HP
• 230 Volt
• 12.0 Amps (measured at 6 MBHP with Aquaflo/Gecko wet end) 10.0 Amps (measured at 4.0/2.0 HP with Sundance/Jacuzzi wet end)
• 48 Frame

New Motor with Sundance/Jacuzzi Piranha Wet End

Comes Complete with the motor and wet end/pump housing. Does not come with the power cord or Hose Barb 6540-171* 

• The Pump is complete with a US Motor and the Sundance/Jacuzzi wet end. The difference between the Factory OEM Pump, available from us, is that ours comes with the original welded bracket on the motor instead of the bracket mount currently used by Sundance. Our pump replaces the original found in your spa that had the mounting bracket welded to it.
• This can be used for other pumps by Sundance by simply adjusting the position of the wet end by loosening the 4 bolts (this is a thru bolt motor) and turning the wet end to the position of the original pump and then retightening the 4 bolts. We send this pump out in the 9:00 o'clock position.
• * The 6540-171 Hose Barb is used on many of the Sundance/Jacuzzi Pumps (you would need to verify) and was originally made of plastic which eventually fails. Please note that the threads are NOT standard MPT threads and you cannot use an over the counter hose barb (from a Hardware Store). If you do it will strip the threads and cause leakage and ruin the Pump Housing (not covered under warranty). See the Related Products below to purchase this item.

Used on the Following Sundance and Sweetwater Spa Models:

• Calypso II - 1997
• Calypso - 1998-1999
• Hartford - All
• Madison - All
• Bahia, Palermo 2000-2006
• Marin 2000-2003

This pump can be used for the following pump numbers by rotating the wet end to match the position of the original pump.

• 6500-269
• 6500-266
• 6500-769
• 6500-766
• 6500-349

Wiring Diagrams

Please Note The wiring diagram for your motor is on the ID plate of the Motor. It may vary from your original wiring on your original spa motor.